Sym Quad Raider 600, Service Manual

Page: 31 / 247

2. MAINTENANCE INFORMATION
2-9
Brake System
Brake System Hose
Check the brake hoses for corrosion or leaking oil.
Brake Fluid
Check brake fluid level in the brake fluid
reservoir. If the level is lower than the LOWER
limit, add brake fluid to UPPER limit. Also check
brake system for leaking if low brake level found
Caution
In order to maintain brake fluid in the reservoir
in horizontal position, do not remove the cap
until handle stop.
Do not operate the brake lever after the cap
had been removed. Otherwise, the brake fluid
will spread out if operated the lever.
Do not mix non-compatible brake fluid together.
Filling Out Brake Fluid
Tighten the drain valve, and add brake fluid.
Operate the brake lever so that brake fluid
contents inside the brake system hoses.
Air Bleed Operation
Connect a transparent hose to draining valve.
Hold the brake lever and open air bleeding valve.
Perform this operation alternative until there is no
air inside the brake system hoses.
Caution
Before closing the air bleed valve, do not release
the brake lever.
Added Brake Fluid
Add brake fluid to UPPER limit lever.
Recommended brake fluid: DOT3 or DOT4 WELL
RUN brake fluid.
Caution
Never mix or use dirty brake fluid to prevent from
damage brake system or reducing brake
performance.
To this chapter contents
Transparent hose
Air bubble
Drain valve
Screws
Diaphragm plate
Upper
Diaphragm
Master cylinder cap