1-2
G E N E R A L I N F O R M AT I O N
NOTE:
If parts replacement is necessary, replace the parts with SUZUKI GENUINE PARTS or their
equivalent.
When removing parts that are to be reused, keep them arranged in an orderly manner so that they
may be reinstalled in the proper order and orientation.
Be sure to use special tools when instructed.
Make sure that all parts used in reassembly are clean, and also lubricated when specified.
When use of a certain type of lubricant, bond, or sealant is specified, be sure to use the specified
type.
When performing service to electrical parts, if the service procedures not require used of battery
power, disconnect the positive terminal.
When removing the battery, disconnect the negative cable first and then the positive cable.
When reconnecting the battery, connect the positive cable first and then the negative cable, and
replace the terminal cover on the positive terminal.
Tighten cylinder head and case bolts and nuts, beginning with larger diameter and ending with
smaller diameter, from inside to outside diagonally, to the specified tightening torque.
Whenever you remove oil seals, gaskets, packing, O-rings, locking washers, cotter pins, cir-clips,
and certain other parts as specified, be sure to replace them with new ones. Also, before installing
these new parts, be sure to remove any odd material from the mating surfaces.
Never reuse a circlip. When installing a new circlip, take care not to expend the end gap larger than
required to slip the circlip over the shaft. After installing a circlip, always ensure that it is completely
seated in its groove and securely fitted.
Do not use self-locking nuts a few times over.
Use a torque wrench to tighten fasteners to the torque values when specified. Wipe off grease or oil
if a thread is smeared with them.
After reassembly, check parts for tightness and operation.
To protect environment, do not unlawfully dispose of used motor oil and other fluids,
batteries and tires.
To protect earth's natural resources, properly dispose of used motorcycles and parts.
*
*
Summary of Contents for GN125F
