Suzuki GN125F, Service Manual

Page: 81 / 148

C H A S S I S
5-3
Remove the bearings on both sides with the special tool,
take off the spacer.
09921-20240: Bearing remover tool
INSPECTION
Inspect the oil seal for wear or damage, replace the oil seal if
there are any defects.
Using the special tools check the axle shaft for runout
and replace it if the runout exceeds the limit.
,
OIL SEAL
FRONT WHEEL AXLE
09900-20606 : Dial gauge (1/100)
09900-20701 : Magnetic stand
09900-21304 : V-block (100mm)
WHEEL RIM
Wheel rim runout:
Service limit: 2.0 mm
Wheel axle runout:
Service limit: 0.25 mm
Make sure that the wheel rim runout does not exceed the
service limit when checked as shown. An excessive amount
of runout is usually due to loose spokes or a bent wheel rim. If
properly tightening the spokes will not correct the runout,
replace the wheel rim.
WHEEL BEARING
Inspect the play of the wheel bearings inner race by hand
while fixing it in the wheel hub.
Rotate the inner race by hand to inspect whether abnormal
noise occurs or rotating smoothly.
Replace the bearing if there is something unusual.
8