Suzuki GN125F, Service Manual

Page: 55 / 148

E N G I N E
3-24
REASSEMBLY
Reassemble the clutch in the reverse order of removal, pay
attention to the following points:
Clutch sleeve hub nut: 30-50 N·m
09920 53710: Clutch driven hub holder -
Bend the clutch sleeve hub washer to the nuts.
Install the clutch drive plates and driven plates.
Install the drive plates as shown in the illustration.
Install the washer, spacer, primary driven gear assembly,
washer and clutch drive hub.
Install the lock washer, tighten the clutch sleeve hub nut to
the specified torque.
Set the marked side of clutch spring faces outside.
Install the clutch push rod, push piece, bearing, washer and
pressure plate.
Install the clutch spring, tighten the clutch spring bolts dia-
gonally.
CAUTION
Install a new gasket and pins.
Install the clutch cover, and tighten clutch cover bolts
.
dia-
gonally
Install a new oil seal ring.
Install the oil filter and oil filter cover.
Tighten three nuts.
Install and adjust clutch cable, and pour engine oil.(Refer to
page 2-8 and page 2-7)
Use new gasket to prevent oil leakage.
CAUTION