Suzuki 2005 DL650K5, Service Manual

Page: 526 / 701

Step 3
1) Turn the ignition switch OFF.
2) Remove the IAP sensor.
3) Connect the vacuum pump gauge to the vacuum port of the
IAP sensor.
4) Arrange 3 new 1.5 V batteries in series
1
(check that total -
voltage is 4.5 – 5.0 V) and connect
-
terminal to the ground -
terminal
2
and
+
terminal to the Vcc terminal
3
.
5) Check the voltage between Vout
4
and ground. Also, check if
voltage reduces when vacuum is applied up to 400 mmHg by
using vacuum pump gauge. (
!
below)
#
09917-47011: Vacuum pump gauge
09900-25008: Multi-circuit tester set
'
Tester knob indication: Voltage (
(
)
Is the voltage OK?
Output voltage (Vcc voltage 4.5 – 5.0 V, ambient temp. 20 –
30 °C, 68 – 86 °F)
YES
• G/B, R or B/Br wire open or shorted to ground,
or poor
3
,
5
or
B
connection.
(Front cylinder side)
• R, B/Br or G/Y wire open or shorted to ground,
or poor
5
,
B
or
L
connection.
(Rear cylinder side)
• If wire and connection are OK, intermittent trou-
ble or faulty ECM.
• Recheck each terminal and wire harness for
open circuit and poor connection.
• Replace the ECM with a known good one, and
inspect it again.
NO
If check result is not satisfactory, replace the IAP
sensor with a new one.
ALTITUDE
(Reference)
ATMOSPHERIC
PRESSURE
OUTPUT
VOLTAGE
(ft) (m) (mmHg) kPa (V)
0

2 000
0

610
760

707
100

94
3.4 – 4.0
2 001

5 000
611

1 524
707

634
94

85
3.0 – 3.7
5 001

8 000
1 525

2 438
634

567
85

76
2.6 – 3.4
8 001

10 000
2 439

3 048
567

526
76

70
2.4 – 3.1
3
ECM coupler (Harness side)
3
13-22 DL650K7/AK7 (’07-MODEL)
PartShark.com
877-999-5686