Suzuki 2005 DL650K5, Service Manual

Page: 383 / 701

ELECTRICAL SYSTEM 8-21
• Connect the gear position switch coupler to the wiring har-
ness.
• Turn the ignition switch to “ON” position and side-stand to
upright position.
• Insert the needle pointed probes to the gear position switch
coupler.
Measure the voltage between Pink and B/W lead wires using the
multi circuit tester when shifting the gearshift lever from low to
top.
#
09900-25008: Multi circuit tester set
09900-25009: Needle pointed probe set
'
Tester knob indication: voltage (V)
$
Gear position switch voltage
NOTE:
* When connecting the multi circuit tester, use the needle
pointed probe to the back side of the lead wire coupler and
connect the probes of tester to them.
* Use a needle pointed probe outer diameter being below 0.5
mm to prevent the rubber of the water proof coupler from dam-
age.
TURN SIGNAL/SIDE-STAND RELAY REMOVAL AND
INSTALLATION
The turn signal/side-stand relay is composed of the turn signal
relay, side-stand relay and diode.
• Remove the seat. (
!
7-4)
• Remove the turn signal/side-stand relay
1
.
• Install the turn signal/side-stand relay in the reverse order of
removal.
Gear
position
1st 2nd 3rd 4th 5th 6th
Voltage Approx.
1.36 V
Approx.
1.77 V
Approx.
2.49 V
Approx.
3.23 V
Approx.
4.10 V
Approx.
4.55 V
V
PartShark.com
877-999-5686