Suzuki 2005 DL650K5, Service Manual

Page: 201 / 701

FI SYSTEM DIAGNOSIS 4-37
“C28” STV ACTUATOR CIRCUIT MALFUNCTION
INSPECTION
Step 1
1) Remove the fuel tank and air cleaner box. (
"
5-15)
2) Turn the ignition switch OFF.
3) Check the STVA coupler for loose or poor contacts.
4) Turn the ignition switch ON to check the STV operation.
STV operating order: Full open
A
→
Open
B
(Approx. 1 seconds later)
Is the operation OK?
Step 2
1) Turn the ignition switch OFF.
2) Check the STVA coupler for loose or poor contacts.
3) Disconnect the STVA coupler.
4) Check the continuity between terminal
1
and ground.
%
STVA continuity:
∞ Ω
(Infinity)
5) If OK, then measure the STVA resistance.
%
STVA resistance: Approx. 7 – 14
Ω
!
09900-25008: Multi circuit tester set
'
Tester knob indication: Resistance (
Ω
)
Is the resistance OK?
DETECTED CONDITION POSSIBLE CAUSE
The operation voltage does not reach the STVA.
ECM does not receive communication signal from
the STVA. • STVA malfunction.
• STVA circuit open or short.
• STVA motor malfunction.
YES Go to Step 2
NO
• Loose or poor contacts on the STVA coupler.
• Open or short circuit in the B/R and R/B wires.
1
2
YES
• Loose or poor contacts on the STVA coupler, or
poor
J
or
L
connection.
• If wire and connection are OK, intermittent trou-
ble or faulty ECM. Recheck each terminal and
wire harness for open circuit and poor connec-
tion.
NO Replace the STVA with a new one.
2
PartShark.com
877-999-5686