Suzuki 1200 bandit, Service Manual

Page: 182 / 447

1G-20 Fuel System:
• After all of the work has been completed, install the
carburetor assembly onto the engine and perform the
following adjustments.
– Engine idle speed. Refer to “Engine Idle Speed
Inspection and Adjustment: in Section 0B”.
– Throttle cable play. Refer to “Throttle Cable Play
Inspection and Adjustment: in Section 0B”.
– Carburetor synchronization. Refer to “Carburetor
Synchronization: ”.
Carburetor Disassembly
B649G11706003
Refer to “Carburetor Assembly Removal and Installation:
”.
Before disassembly, prepare a clean and well lit work
place where carburetor components can be laid out
neatly and will not get lost. Study the service manual
carburetor diagram and familiarize yourself with
component locations and the different fuel circuits and
their routing through the carburetor.
CAUTION
!
• Avoid removing the throttle position
sensor from the carburetor body unless
absolutely necessary.
• The TP sensor is preset at the factory.
Prior to disassembly, mark the throttle
position sensor’s original position with
paint or a scribe for accurate reinstallation.
1) Disconnect the fuel hose (1).
2) Disconnect the air vent hoses (2).
3) Disconnect the carburetor heater terminal lead wires
(3). (For E-02, 19)
4) Remove the starter (enricher) plate (4) by removing
the fitting screws.
5) Remove the upper and lower carburetor set shafts.
6) Separate the carburetor assembly.
I649G1170034-02
1
2
2
3
I649G1170035-02
4
I649G1170036-01
I649G1170037-01