Installation
SUSPA ELS3 HeavyDuty - Installation Instruction
Page 38
Mounting accessories for mounting the customized tabletop
IMPORTANT
The tabletop is not available in the SUSPA scope of supply since this is freely
selectable by the customer depending on the application and design requirement.
Figure 21 Mounting the tabletop (not included in the scope of supply) on the 2-leg HeavyDuty
subframe
With the customer's selection of the tabletop dimensions, you have to note that the
projection of the tabletop borders to the HeavyDuty subframe is only 10 cm maximum, since
otherwise there is a great risk of tipping over on load application.
For mounting the tabletop provided by the customer, the 2-leg system is placed with the
HeavyDuty subframe on the tabletop (not included in the scope of supply by SUSPA). The
system can be mounted on the tabletop with the help of the screws supplied along with the
remaining items in the scope of supply.
You can use the rear wall screws (5.0x60) to mount the tabletop on the cross beams S and
the cross beams E. The fixing plates can be mounted with the UNITA screws (7.0x55) to the
tabletop.
You have to first drill suitable bore holes in the tabletop before you can insert these
mounting screws. The diameter of the preliminary drilling depend on the tabletop material
used by the customer.
You can insert the rear wall screws and the UNITA screws with the help of screwdriver or a
battery-operated screwdriver.
12x
Rear wall
screw,
5.0x60
12x
UNITA
Screws 7.0x55
Fixing plate
Cross beam S
Cross beam E
