Installation
SUSPA ELS3 HeavyDuty - Installation Instruction
Page 34
IMPORTANT
In order to prevent damage to the lifting elements and the HeavyDuty subframe,
use only the screws and fastening elements that are included in the scope of supply.
Assembling the foot bases on the lifting elements
Figure 15 Assembling the foot bases of the 2-leg system
Place the foot bases on the lifting elements and fasten these with the M8x50 screws and M8
washers supplied to the lifting elements. Use a size 6 Allen wrench to fit the screws.
Check the mounting screws of the foot bases in order to ensure that they are fastened
securely to the lifting elements. Take care not to over-tighten the lifting element-mounting
screws (recommended tightening torque: 10 Nm).
Fit the leveling feet with screws by hand in the foot bases. The alignment of the 2-leg system
with the HeavyDuty subframe is described in section 6.5 "Aligning components".
4x
Leveling
foot
8x
Screw
M8x50
8x
Washer
8.4x15
Foot base with
leveling feet
Lifting elements /
Columns
