Supero SuperWorkstation 5036T-T, User Manual

Page: 54 / 98

6-2
S
UPER
W
ORKSTATION 5036T-T Manual
6-2 Front Control Panel
The front control panel must be connected to the JF1 connector on the motherboard
to provide you with system status and alarm indications. A ribbon cable has bundled
these wires together to simplify this connection. Connect the cable from JF1 on the
motherboard (making sure the red wire plugs into pin 1) to the appropriate comn-
nector on the front control panel PCB (printed circuit board). Pull all excess cabling
over to the control panel side of the chassis.
The LEDs inform you of system status - see Figure 6-1 for details. Figure 6-2 shows
the SC733TQ-465B features included on the front of the chassis. See Chapter 5
for details on JF1.
Figure 6-1. Front Control Panel LEDs
Power
NIC
HDD
Overheat
Indicates power is being supplied to the system.
Indicates network activity the GLAN port.
Indicates SATA hard disk/CD-ROM drive activity.
Indicates an overheat condition or fan failure.