Supero SuperWorkstation 5036T-T, User Manual

Page: 18 / 98

2-2
S
UPER
W
ORKSTATION 5036T-T User's Manual
To maintain proper cooling, always keep all chassis panels closed and all SATA
•
carriers installed when not being serviced.
2-3 Setting Up the System
You should fi rst open the left side panel (when facing the front of the chassis)
to make sure the motherboard is properly installed and all connections have been
made.
Checking the Motherboard Setup
Accessing the inside of the system (Figure 2-1): Begin by removing the two 1.
screws from the back lip of the side cover (this is the left cover when looking
at the chassis from the front.) Grab the handle and gently pull the side cover
out to release it from its position. Once the side cover is out of its position,
slide the cover out of the chassis.
Check the CPU (processor): You may have a processor already installed into 2.
the system board. The processor should have its own heatsink attached. See
Chapter 5 for instructions on processor installation.
Check the system memory: 3. Your system may have come with system
memory already installed. Make sure all DIMMs are fully seated in their slots.
For details on adding system memory, refer to Chapter 5.
Installing add-on cards: 4. If desired, you can install up to six add-on cards to
the system. See Chapter 5 for details on installing PCI-E/PCI-X/PCI add-on
cards.
Check all cable connections and airfl ow: Make sure all power and data cables 5.
are properly connected and not blocking the airfl ow. See Chapter 5 for details
on cable connections.
Checking the Drive Bay Setup
Next, you should check to make sure the peripheral drives and the Serial ATA drive
and Serial ATA backplane have been properly installed and all essential connec-
tions have been made.
Accessing the peripheral drive bays: To install or remove a component in the 1.
3.5" and/or 5.25" drive bay(s), you will need to remove the side chassis cover.