Supero SuperWorkstation 5036T-T, User Manual

Page: 49 / 98

Chapter 5: Advanced Serverboard Setup
5-21
LAN1/LAN2 Enable/Disable
Change the setting of jumper JPL1 or
JPL2 to enable or disable the LAN1 and
LAN2 Ethernet ports, respectively. See
the table on the right for jumper set-
tings. The default setting is enabled.
LAN1/LAN2 Enable/Disable
Jumper Settings (JPL1/JPL2)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
Audio Enable/Disable
JPAC enables or disables the onboard
audio connections. See the table on the
right for jumper settings. The default
setting is Enabled.
Audio Enable/Disable
Jumper Settings (JP5)
Pin# Defi nition
1-2 Enabled
2-3 Disabled
SMBus to PCI Slots
Jumper Settings (JI
2
C1/JI
2
C2)
JI
2
C1/ JI
2
C2 Setting
Pins 1-2 Enabled
Pins 2-3 Disabled
SMBus to PCI/PCI-E Slots
Jumpers JI 2 C1 and JI 2 C2 allow you to
connect the PCI slots to the System
Management Bus (I 2 C). The default
setting is disabled. See the table on the
right for jumper settings.
Watch Dog Enable/Disable
JWD controls the Watch Dog function.
Watch Dog is a system monitor that
can reboot the system when a software
application hangs. Jumping pins 1-2
will cause WD to reset the system if an
application hangs. Jumping pins 2-3
will generate a non-maskable interrupt
signal for the application that hangs.
See the table on the right for jumper
settings. Watch Dog must also be en-
abled in BIOS.
Note: When enabled, the user needs to
write their own application software in
order to disable the Watch Dog Timer.
Watch Dog
Jumper Settings (JWD)
Jumper Setting Defi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled