Supero SuperWorkstation 5036T-T, User Manual

Page: 45 / 98

Chapter 5: Advanced Serverboard Setup
5-17
Audio Input CD Header
Pin Defi nitions (CD-IN)
Pin# Defi nition
1 Left Stereo Signal
2 Ground
3 Ground
4 Right Stereo Signal
CD and Audio FP
A 4-pin CD header (CD-IN) and an
auxiliary header (Audio FP) allow you
to use the onboard sound for audio
CD playback. Connect an audio cable
from your CD drive to the header
that fi ts your cable's connector. Only
one header can be used at any one
time. See the tables at right for pin
defi nitions.
Front Panel Audio Control
When front panel headphones are
plugged in, the back panel audio output
is disabled. This is done through the FP
Audio header (Audio FP). If the front
panel interface card is not connected to
the front panel audio header, jumpers
should be installed on pin pairs 1-2,
5-6, and 9-10 of the Audio FP header.
If these jumpers are not installed, the
back panel line out connector will be
disabled, and pin 1 of the microphone
in will be left fl oating, which can lead to
excessive back panel microphone noise
and crosstalk. See the table at right for
pin defi nitions.
Front Panel Audio Pin
Defi nitions (Audio FP)
Pin# Defi nition
1 MIC_L
2 Audio Ground
3 MIC_R
4 FP Audio Detect
5 Line_2_R
6 Ground
7 FP_Jack Detect
8 Key
9 Line_2_L
10 Ground
High Defi nition Audio (HDA)
The X8SAX features a 7.1+2 Channel
High Defi nition Audio (HDA) codec that
provides 10 DAC channels, simultane-
ously supporting 7.1 sound playback
and two channels of independent ste-
reo sound output (multiple streaming)
through the front panel stereo out via
the front L&R, rear L&R, center and
subwoofer speakers. This feature is
activated with the software included in
the CD-ROM that came with your moth-
erboard. Sound is output through the
Line In, Line Out and MIC jacks.
Grey: Side
Surround
Black: Back
Surround
Orange:
CEN/LFE