Supero SuperWorkstation 5036T-T, User Manual

Page: 61 / 98

Chapter 6: Advanced Chassis Setup
6-9
Installing Components in the 5.25" Drive Bays
The 5036T-T has two 5.25" drive bays above the SATA drive bays. Components
such as a fl oppy drive, IDE hard drives or CD-ROM drives can be installed in these
5.25" drive bays.
Accessing the drive carrier
First power down the system and unplug the power cord. 1.
Remove the top/left chassis cover to access the drive components. 2.
With the cover off, remove the two or four screws that secure the drive carrier 3.
to the chassis (one side only) then push the entire empty drive carrier out
from the back.
Adding a DVD-ROM drive
Remove the guide plate from right side of the empty drive carrier and screw it 1.
into the right side of the DVD-ROM drive using the holes provided (see Figure
6-6).
Slide the DVD-ROM into the bay and secure it to the chassis with the drive 2.
carrier screws you fi rst removed.
Attach the power and data cables to the drive. 3.
Replace the top/left chassis cover before restoring power to the system. 4.
Adding an IDE or fl oppy drive
Install a fl oppy or IDE drive into one of the removed empty drive carriers 1. with
the printed circuit board side toward the carrier so that the drive's mounting
holes align with those in the carrier.
Secure the drive to the carrier with four screws then slide the assembly into 2.
the bay and secure it to the chassis with the drive carrier screws you fi rst
removed.
Attach the power and data cables to the drive. 3.
Replace the top/left chassis cover before restoring power to the system. 4.
Note: A red wire typically designates the location of pin 1. You should keep the
drive carriers inserted in any unused drive bays to reduce EMI and noise and to
facilitate the airfl ow inside the chassis.