Supero SUPER P3TDDE, User Manual

Page: 79 / 96

5-9
Chapter 5: FastTrak 100 RAID Controller
Windows NT4
Installing Drivers During Windows NT 4.0 Installation
1. Start the system installation by booting from the Windows NT disk:
a) Floppy install: boot the system with the Windows NT installation diskettes.
b) Floppyless install: boot from floppy and type “WINNT /B”. After files have
been copied, the system will reboot. On the reboot, press the “F6” key when
the message “Setup is inspecting your computer’s hardware configuration…”
appears.
c) CD-ROM disk install: boot from the CD-ROM disk and press the “F6” key when
the message “Setup is inspecting your computer’s hardware configuration…”
appears.
2. When the “Windows NT Setup” window is generated, press “S” to Specify an
Additional Device(s).
3. Press “O” to select “Other” and press the “Enter” key.
4. Insert the Promise Technology
®
FastTrak100 driver diskette into drive A: and press
the “Enter” key.
5. Choose “Win NT Promise FastTrak100 (tm) Controller” from the list that appears on
screen, then press the “Enter” key.
6. The Windows NT Setup screen will appear again saying “Setup will load support
for the following mass storage devices:” The list will include “Win NT Promise
FastTrak100 (tm) controller”.
NOTE : If you need to specify any additional devices to be installed, do so at this time.
Once all devices are specified, continue to step 7.
7. From the Windows NT Setup screen, press the Enter key. Setup will now load all
device files and then continue the Windows NT installation.
8. After a successful installation, the “SCSI Adapter Setup” box will show that the
“Win NT Promise FastTrak100 (tm) Controller” driver has been installed.
Installing Driver with Existing Windows NT 4.0
WARNING : If you plan to move your boot drive to a mirrored RAID 1
FastTrak array, hard drives should NOT be connected to the FastTrak100
controller card before performing the following procedure. The FastTrak100
drivers must be loaded on the system hard drive (running under the existing
hard drive controller) before any hard drives are connected to the FastTrak100
controller card.
1. Choose “Settings” from the “Start” menu.
2. Choose “Control Panel” from the “Settings” menu.
3. Double-click on the “SCSI Adapters” icon, which generates the “SCSI Adapters”
dialog box.
4. Choose “Drivers,” and then press “Add.”