5-7
Chapter 5: FastTrak 100 RAID Controller
13. Press “Next,” then “Finish,” then “Yes” when asked if you want to restart your
computer. Be sure to remove the diskette from drive A:.
Windows 95
1. After installing the FastTrak100 controller card and configuring the hard drives,
partition and format your hard drive(s), if necessary.
2. Install Windows 95 normally.
3. After installation, go to the “Start” menu and choose “Settings.”
4. From the “Settings” menu, choose “Control Panel.”
5. In the “Control Panel” window, double-click on the “System” icon.
6. In the “System” window, choose the “Device Manager”tab.
7. In the hierarchical display under “Other Devices” is a listing for “PCI Mass Storage
Controller.” Choose it and then press the “Properties” button.
8. Choose the “Driver” tab in the “Properties” window, and then press the “Update
Driver” button.
9. When asked if you want Windows to search for the driver, choose “Yes
(recommended).”
10. Insert the “FastTrak100 Driver” diskette into the A: drive, then press “Next.”
11. When Windows informs you that it was unable to find the drivers, press “Other
Locations…”
12. In the “Select Other Location” dialog box, type “A:\WIN95-98”.
13. Press the “Next” button. A message informing you that Windows 95 has found
“Win95-98 Promise FastTrak100 (tm) Controller” should appear.
14. Press “Finish.” (If Windows can’t find the “FastTrak100.MPD” file, type “A:\WIN95-
98” in the “Copy files from:” text box).
15. Choose “Yes” when asked if you wish to restart the system, and remove the
diskette.
Installing Drivers with Existing Windows 95/98
The following three sections detail the installation of FastTrak100 drivers on a system
that has Windows 95/98 already installed. If you’re installing the FastTrak100 drivers
on a system during a Windows 95/98 installation, see “Installing Drivers During
Windows 95/98 Installation” on Page 5-6.
Windows 98
1. After installing the FastTrak100 controller card and configuring the hard drives,
power up the system and boot Windows.
2. The “Add New Hardware Wizard” will appear, informing you that it has found a “PCI
RAID Controller.”
3. Check the “Search for the best driver for your device” box and click the Next button.
4. Check the “Specify a Location” box and click Next button.
5. Type “A:\WIN95-98” in the text box that appears.
Summary of Contents for SUPER P3TDDE
Page 1: ...SUPER P3TDDE USER S MANUAL Revision 1 0c SUPER...
Page 9: ...Chapter 1 Introduction 1 3 Introduction SUPER P3TDDE Figure 1 1 SUPER P3TDDE Image...
Page 44: ...3 6 SUPER P3TDDE User s Manual Notes...
Page 70: ...4 26 SUPER P3TDDE User s Manual Notes...
