Supero SUPER P3TDDE, User Manual

Page: 74 / 96

5-4
S
UPER P3TDDE User's Manual
Installing Driver in Existing Windows 2000 System
After installing the FastTrak100 card and rebooting your system, Windows 2000
setup will show a “New Hardware Found” dialog box. Under Windows 2000, the
“PCI RAID Controller” will be displayed.
1. In the dialog box, choose “Driver from disk provided by hardware manufacturer”
button.
2. In the A: drive, insert the FastTrak100 driver diskette.
3. Type “A:\WIN2000” in the text box. Press “Enter”.
4. Choose “Win2000 Promise FastTrak100 Controller” from the list that appears on
screen, then press the “Enter” key.
5. The Windows 2000 Setup screen will appear again saying “Setup will load support
for the following mass storage devices – Win2000 Promise FastTrak100 controller”.
The FastTrak100 driver will now be copied on to the system and entered into the
Windows 2000 driver database.
6. When the “System Settings Change” dialog box appears, remove the floppy diskette
and click on “Yes” to restart the system. Windows 2000 will then restart for the driver
installation to take effect.
7. Power off your system, then attach your hard drives to the FastTrak100 controller
card.
Confirming Windows 2000 Installation
1. From Windows 2000, open the Control Panel from “My Computer” followed by the
System icon.
2. Choose the “Hardware” tab, then click the “Device Manager” tab.
3. Click the “+” in front of “SCSI & RAID Controllers hardware type.” The driver
“Win2000 Promise FastTrak/FastTrak100 Controller” should appear.
WARNING : If you will be moving the boot drive containing the
existing Windows 2000 operating system to a mirrored RAID 1
array on the FastTrak100 card, the FastTrak100 driver MUST
be loaded to the hard drive while it is still attached to your
existing hard drive controller. Do not attach this drive or any
other hard drive to the FastTrak100 controller card before
completing this step.