Supero SUPER P3TDDE, User Manual

Page: 78 / 96

5-8
S
UPER P3TDDE User's Manual
6. Insert the “FastTrak100 Driver” diskette in drive A:.
7. Click on “Next.” The Add New Hardware wizard will say it has found “Win95-98
Promise FastTrak100 controller”.
8. Click on “Next,” and then on “Finish.”
9. Choose “Yes” when asked if you want to restart your computer. Be sure to eject
the diskette from drive A:.
Windows 95
1. After installing the Ultra100 controller card and configuring the hard drives, power
up the system and boot Windows.
2. The “Update Device Drive Wizard” will appear, informing you that it has found a “PCI
Mass Storage Controller.”
3. Insert the “FastTrak100 Driver” diskette in drive A:.
4. Type “A:\WIN95-98” in the text box, then click on “Next. Windows will inform you
that it has found the “Win95-98 Promise FastTrak100 controller”.
5. Click on “Finish,” and when prompted, insert the “FastTrak100 Driver” diskette and
click on “OK.”
6. If a message informing you that the file “FastTrak100.MPD” cannot be found, go to
the “Copy files from:” text box and type: “A:\WIN95-98”.
7. Choose “Yes” when asked whether you want to start your computer. Be sure to
remove the diskette from drive A
Confirming Driver Installation in Windows 98/95
To confirm that the driver has been properly loaded in Win 95/98, perform the following
steps:
1. Choose “Settings” from the “Start” menu.
2. Choose “Control Panel,” and then double-click on the “System” icon.
3. Choose the “Device Manager” tab, and then click the “+” in front of “SCSI & RAID
controllers. ” “Win95-98 Promise FastTrak100 controller” should appear.
DOS/Windows 3.1x
For first-time installation, follow the standard procedure of installing DOS on to your
hard disk (partition all hard drives with FDISK and format before performing the
following procedure):
1. Insert “Disk 1” of your DOS installation diskettes into drive A:.
2. Type “A:SETUP” at the “A:\” prompt.
3. Continue with normal DOS installation procedure, and refer to your DOS manual
for additional details.
NOTE : The FastTrak100 BIOS supports both DOS and Windows 3.1x without
software drivers.