Supero 1028GQ-TR, User Manual

Page: 78 / 146

6-4
S
UPER
S
ERVER 1028GQ-TR(T) User's Manual
6-5 Hard Drive Installation
The SC118GQE chassis has two externally accessable hot-swap 2.5" drive bays
and space for two internall fixed 2.5" drives.
Figure 6-3. Drive Bays
Note : Enterprise level hard disk drives are recommended for use in Supermicro
chassis and servers. For information on recommended HDDs, visit the Supermicro
Web site at http://www.supermicro.com/products/nfo/files/storage/SAS-CompList.
pdf.
Internal HDDs
External HDDs
6-4 Control Panel
The control panel, located on the front of the chassis, must be connected to the JF1
connector on the serverboard to provide you with system status indicators. These
wires have been bundled together as a ribbon cable to simplify the connection.
Connect the cable from JF1 on the serverboard to the appropriate header on the
Control Panel printed circuit board. Make sure the red wire plugs into pin 1 on both
connectors.
Pull all excess cabling out of the airflow path.
The control panel LEDs inform you of system status. See "Chapter 3: System
Interface" for details. Details on the JF1 header can be found in "Chapter 5:
Advanced Serverboard Setup."