Supero 1028GQ-TR, User Manual

Page: 69 / 146

Chapter 5: Advanced Serverboard Setup
5-21
VGA Enable/Disable
JPG1 allows you to enable or disable
the onboard VGA port. The default
position is on pins 1 and 2 to enable
VGA.
VGA Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
ME Manufacturing Mode Select
Close pin 2 and pin 3 of jumper
JPME2 to bypass SPI flash security
and force the system to operate in
the Manufacturer (ME) mode, allowing
the user to flash the system firmware
from a host server for system setting
modifications.
ME Mode Select
Jumper Settings
Jumper Setting Definition
Pins 1-2 Normal (Default)
Pins 2-3 Manufacture Mode
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system moni-
tor that can reboot the system when
a software application hangs. Close
pins 1-2 to reset the system if an ap-
plication hangs. Close pins 2-3 to
generate non-maskable interrupt sig-
nals for the application that hangs.
See the table on the right for jumper
settings. Watch Dog must also be en-
abled in the BIOS
Watch Dog
Jumper Settings
Jumper Setting Definition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
BMC Enable
Jumper JPB1 allows you to enable
the embedded onboard (Baseboard
Management controller (BMC) to
provide IPMI 2.0 support on the
motherboard.
BMC Enable
Jumper Settings
Jumper Setting Definition
Pins 1-2 BMC Enable
Pins 2-3 Normal