Supero 1028GQ-TR, User Manual

Page: 117 / 146

Chapter 7: AMI BIOS
7-27
sSATA Port 0-Port 3
Select Enabled to enable an sSATA port specified by the user. The options are
Disabled and Enabled.
sSATA Port 0-Port 3 Hot Plug
This feature designates this port for hot plugging. Set this item to Enabled for
hot-plugging support, which will allow the user to replace an sSATA drive without
shutting down the system. The options are Disabled and
Enabled .
sSATA Port 0-Port 3 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to start a
COMRESET initialization to the device. The options are
Disabled and Enabled.
sSATA Port 0-Port 3 sSATA Device Type
Use this item to specify if the sSATA port specified by the user should be
connected to a Solid State drive or a Hard Disk Drive. The options are Hard
Disk Drive and Solid State Drive.

Server ME (Management Engine) Configuration
This feature displays the following system ME configuration settings.
•
General ME Configuration
•
Operational Firmware Version
•
Recovery Firmware Version
•
ME Firmware Features
•
ME Firmware Status #1
•
ME Firmware Status #2
•
Current State
•
Error Code
Altitude
This feature indicates the altitude of the platform this machine is located above the
sea level. The value is shown in meters. If the value is unknown, enter the number
"80000000."
MCTP (Management Component Transport Protocol) Bus Owner
This feature indicates the location of the MCTP Bus owner. Enter 0s to all fields to
disable the MCTP Bus owner.