11
Chapter 3: Setup and Installation
3.
Once the boot sequence is interrupted, it will display menu options as shown in
Figure 3-7
.
Use the "H" option to set hardware information by typing the character
H
. This will
display the hardware information that can be changed as shown in
Figure 3-8
.
4.
To choose the boot from a fallback image, type the command:
rflag=1
5.
Type
Save
to save the hardware information.
6.
Type
Exit
to exit the hardware information menu.
7.
Type
J
to boot the image. In this case it will boot from a fallback image.
NOTE:
The numbers in the Product Type entry change depending upon the
switch you are using.
Figure 3-8. Setting Hardware Information
Summary of Contents for SuperBlade SBM-GEM-X2C
