Supermicro SuperBlade SBM-GEM-X2C, User Manual

Page: 126 / 334

Superblade Network Modules User’s Manual
40
QoS
Clicking on the Q
O
S link of the S
YSTEM
page allows you to configure QoS through
following control tabs:
• Basic Settings
• Classmap
• Policymap
• COSQ Algorithm
• Cosq Traffic Class
By default, the B
ASIC
S
ETTINGS
tab is loaded.
Ports List (Incoming) Specifies the Incoming Port List for which the filter has to be applied.
Ports List (Outgoing) Specifies the Outgoing Port List for which the filter has to be applied.
Protocol Specifies the type of protocol.
Message Code
Specifies the Message Code to be checked for ICMP Packets. (This is
enabled only if ICMP is chosen.)
Message Type
Specifies the Message Type to be checked for ICMP Packets. (This is
enabled only if ICMP is chosen.)
Priority Specifies the Priority for the filter.
TOS Specifies the Type of Service for the access list.
ACK Bit
Indicates the TCP Ack Bit to be checked against the incoming packet.
(This is enabled only if TCP is chosen.)
RST Bit
Indicates the TCP Reset Bit to be checked against the incoming packet.
(This is enabled only if TCP is chosen.)
Source Port (Min)
Specifies the TCP/UDP source port from which the access list has to be
applied.
Source Port (Max)
Specifies the TCP/UDP source ports to which the access list has to be
applied.
Destination Port (Min)
Specifies the TCP/UDP destination port from which the access list has to
be applied.
Destination Port (Max)
Specifies the TCP/UDP destination port to which the access list has to be
applied.
Table 7-23. IP Extended ACL Configuration Page Parameters (Continued)
Parameter Description