Sunrise telecom XTT 5000, User Manual

Page: 63 / 181

Throughput Testing
Stream - IP Setup Home
Use the IP tab to configure the IP addresses for the stream/s, after selecting UDP as
part of the Frame Setup on the Stream Table . See Auto Fill to configure multiple
streams.
Statistic(s) Options Details
IP Source and IP
Destination Enter the new IP
address source
and destination
pairs to use.
Enter the address using the pop up
number pad.
• The IP address is the network layer
address that identifies the source
and destination of the test frames.
IP Gateway
(Ver4) Specify the
gateway
addresses.
Leave the gateway value as
000.000.000.000 to indicate no
gateway.
IP Version IP Version 4, IP
Version 6. Select the IP Version.
IP Option (Ver4) Yes, No Opt whether or not to include the
"option type" IP header field.
IP Header Length
(Ver4) Set the number
of 32-bit (4-
byte) words.
These form the header.
• A setting of 5 indicates an IP
header of 20 bytes.
Type of Service
(Ver4)
RFC1349,
RFC2474
Select the Type of Service protocol.
• This selection determines the rest
of the third column.
• See the TOS parameters .
Flag Don’t
Fragment (Ver4) Yes, No Select whether or not to fragment the
packet.
Flag More
Fragment (Ver4)
1: Additional
fragments follow
the current one;
0: No additional
fragment bits
follow.
The packets generated by the XTT
5000 are never actually fragmented,
even if the fragmentation bits are set
otherwise.
Fragment Offset
(v4) 0-8191 bits Enter the position of the fragment in
the original datagram.
• Leave at 0 if you are unsure of
what to select
Time to Live
(Ver4) 0-255 hops Enter the time to live.
64 and 128 are commonly used.
Protocol (Ver4)
The protocol
value selected
is the number
placed into the
IP header; it
doesn't indicate
View the
originating
protocol module.
Set at TCP in a TCP/UDP
configuration.
• The assigned values are
maintained by the Internet
Assigned Numbers Authority
(IANA) ; available on at
www.ianan.org/assignments/protoc
57