Sunrise telecom XTT 5000, User Manual

Page: 78 / 181

XTT 5000 User's Manual
Stream - TCP Setup Home
Use the TCP tab to configure the TCP ports and header, after selecting UDP as part of
the
Frame Setup on the Stream Table . See Auto Fill to configure multiple streams.
Selecting TCP puts a TCP header into the IP packet datagram but does not
establish a true TCP connection with the far end. This ”static TCP” is useful for
entering a proper TCP port value to pass traffic through firewalls and similar security
features on a router, but does not test a live TCP connection.
Parameter Options Details
UDP Source 0x1 to 0xFFFF Enter the port address,using the pop up
number pad.
UDP Destination 0x1 to 0xFFFF Enter the port address,using the pop up
number pad.
Column 2: TCP Header Config
Statistic Meaning
UDP Source Enter the port address,using the pop up number pad; 0x0
to 0xFFFFFFFF.
Acknowledgement
Number
Expected next Sequence Number, sent by receiver.
Data Offset (4
bits) Size of TCP header; also offset of the packet to the data.
Reserved 6 bits Normally unused: set to 0.
URG Enter the value for the Urgent Pointer Control Bit.
PSH Enter the value for the Push Function Control Bit.
RST Enter the value for the Reset the connection Control Bit.
SYN Enter the value for the Synchronize sequence number
Control Bit.
FIN Enter the value for the No more data from sender Control
Bit.
Window Size
(Hex)
Increase the TCP congestion window size up to 1 Gb;
*0x0x to 0xFFFF
Where do you want to go next?
Throughput Stream Table Setup
Throughput Summary Results
Throughput Aggregate Results
Throughput Stream Results
Home
72