Sunrise telecom XTT 5000, User Manual

Page: 45 / 181

Port Setup
SFP Port Configuration Home
Interface : Set the Ethernet interface: Gigabit Ethernet, 100Base FX
Auto-Negotiation : Select ON to auto-negotiate with the link partner, selecting the
highest mutually compatible rate between the two ports.
Parameter Options Details
Pause On, Off Set to On, the unit will not stop transmitting
on receipt of flow control packets.
Pause Frame
Delay 0 to 3355 μ s Set the length of time indicated by the Pause
frame sent by the module.
Asymmetric
Pause
On, Off Determine if the TX port will send Pause
frames even if the receiver has disabled Pause.
Auto-Negotiation Result
When Auto-Negotiation is On, view the results of the negotiations. Data includes:
Statistic Details
Line Rate
Duplex XTT 5000 duplex: Half or Full
Link Partner AN Whether the link partner uses Auto-Negotiation; shows as
Disable or Enable.
Local RX, Tx
Pause Enable or Disable status of pause transmission by XTT
5000.
Remote RX, TX
Pause
Enable or Disable status of link partner's transmission by
XTT 5000.
Status Link status.
Remember to make sure the laser is on for testing.
Where do you want to go next?
Port_Address : Set the local port parameters.
Throughput Test Setup
RFC2544/NE Applications
Loopback Test Setup
Throughput Summary Results
IP Test Setup
IP Testing
Throughput Test Setup
IP Ping Testing
Home
39