IP Ping Testing
IP Setup
Parameter Options
Details
Source IP Mode
DHCP
: The test port will obtain an IP
source and gateway address from a
server. A status field shows the
message exchange, under 'Detail'.
Static
: Manually assign the network
parameters;the port will use the same
IP address each time it connects.
Set how the unit
will obtain an IP
source and
gateway
address.
DHCP Note
:
Press 'Reset' to
start the process
over.
Source IP
Enter the static IP address to use for
the test port.
Static only.
Gateway Specify
Static only.
Subnet Mask
Specify the subnet mask.
Static only.
The default is
255.255.255.0
.
DNS Specify
server address.
Static only.
IP Test Type
: Verify and test IP
connectivity.
: See each hop of the test
route; only a subset of the remaining
items will apply.
Choose the type
of IP test to run.
Configure the
test tab.
VLAN Setup
To add (turn On) VLAN tags, touch the corresponding VLAN button.
•
Up to three VLANS are available.
•
Enter the TPID, PPI, CFI, and VLAN ID for each VLAN; touch a button, then use
the number pad to enter the data. See
for technology
information.
IP Test Basics
Select IP TEST as the test type from the
, to perform an IP test. Select the IP
Setup tab to configure the IP setup.
Where do you want to go next?
113
Summary of Contents for XTT 5000
