Sun Oracle Fire X4470 M2, Service Manual

Page: 141 / 194

Chapter 8 Troubleshooting the Server and ILOM Defaults 8-7
4. You can perform any of the following tasks or type
boot
to exit the Preboot
Menu.
■
Enable remote access to the Preboot Menu.
For instructions, see “Edit Preboot Menu for Remote Serial Access” on page 8-7 .
■
Restore Oracle ILOM settings to their defaults.
For instructions, see “Reset Oracle ILOM Configuration Using the Preboot
Menu” on page 8-10 .
■
Restore the serial connection between Oracle ILOM and a host console.
For instructions, see “Restore Access to the Serial Console Using the Preboot
Menu” on page 8-10 .
■
Restore the SP firmware image.
For instructions, see “Restore the SP Firmware Image Using the Preboot Menu”
on page 8-12 .
■
Review the commands supported in the Preboot Menu.
For command details, see Section 8.3.5 “Preboot Menu Command Summary” on
page 8-13 .
▼
Edit Preboot Menu for Remote Serial Access
1. Access the Preboot Menu as described in “Access the Preboot Menu” on
page 8-6 .
2. At the
Preboot>
prompt, type
edit
.
The Preboot Menu enters edit mode.
In edit mode, the Preboot Menu displays its selections one-by-one, offering you a
chance to change each one.
■
To change a setting, type the new value, then press Enter.
■
To skip to the next setting, press Enter.
3. Press Enter to move through the settings until the
bootdelay
setting appears.
4. To change the
bootdelay
setting, type
3
,
10
, or
30
, then press Enter.
This value (
3
,
10
, or
30
) specifies the number of seconds the SP boot process
delays while waiting for your input.
The Preboot Menu re-displays the
bootdelay
setting with the new value.
Set 'bootretry' to -1 to disable the time-out.
Preboot>