Sun Microsystems Blade X6450, Service Manual

Page: 72 / 162

2-42 Sun Blade X6450 Server Module Service Manual • May 2009
15. Press F8 to get a list of boot devices.
16. Set the USB flash device as the primary boot device, and save and exit.
The server module boots to DOS from the USB flash device, and a DOS prompt
appears:
>
17. When the DOS prompt appears, run the following command, depending on
whether your SP is ELOM-based or ILOM-based:
■
For ELOM-based service processors:
socflash
SP binary backup file
Where SP binary is name of the firmware file.
Where backup file is the backup filename.
For example:
socflash x6450bmc.bin backup.bin
■
For ILOM-based service processors:
socflash -p1 -f
filename
Where filename is the name of the ILOM .bin file.
For example:
>
socflash -p1 -f ilom-X6450.bin
18. After a successful flash, remove the server module from the chassis, and remove
the jumper caps from jumper blocks J19 and J44.
19. If necessary, move the jumper cap from pins 2 and 3 to pins 1 and 2 on jumper
J51 (revision 2 only).
20. Insert the server module into the chassis, leaving the system powered off for at
least 30 seconds.
The server module must be set up to view the BIOS Setup Utility.
21. Power on the system; watch the display, and when prompted, press F2 to enter
the BIOS Setup Utility.
22. Verify the status of the BMC and the BMC version in the BIOS Setup Utility
under the Server screen.
23. Exit the BIOS Setup Utility.
Press Esc or F10 to exit.