Sun Microsystems Blade X6450, Service Manual

Page: 117 / 162

Chapter 3 Maintaining the Server 3-43
2. Remove the main cover as described in “To Remove the Main Cover” on
page 3-15 .
The fabric expansion module connector is located on the left side of the center
support bracket.
3. Press down on the ejector lever to unlock the edge of the fabric expansion
module.
The ejector lever is located on the left-side support bracket. Unlocking the module
allows you to disconnect the module from the motherboard.
4. To disconnect, gently lift the edge of the module off the connector on the
motherboard.
The other end of the module is secured under clips on the center support bracket
(see
FIGURE 3-21
).
FIGURE 3-21
Removing a Fabric Expansion Module
5. When the module is disconnected, pull the card away from the center support
bracket, and remove it from the server.