Subaru Impreza 2003, Service Manual

Page: 2292 / 3610

DS-20
DRIVE SHAFT SYSTEM
FRONT AXLE
9) Install the disc brake caliper on housing.
Tightening torque:
80 N·m (8.2 kgf-m, 59 ft-lb)
10) Connect the stabilizer link.
Tightening torque:
45 N·m (4.6 kgf-m, 33 ft-lb)
CAUTION:
Use a new self-locking nut.
11) Using the ST1 and ST2, pull the front drive
shaft into place.
ST1
922431000 AXLE SHAFT INSTALLER
ST2 927390000 ADAPTER
12) While depressing the brake pedal, tighten a
new axle nut to specified torque and lock it secure-
ly.
Tightening torque:
220 N·m (22.4 kgf-m, 162 ft-lb)
CAUTION:
Be sure to tighten the axle nut to specified
torque. Do not overtighten it as this may dam-
age the wheel bearing.
13) After tightening the axle nut, lock it securely.
14) Install the ABS wheel speed sensor on hous-
ing.
Tightening torque:
32 N·m (3.3 kgf-m, 23.9 ft-lb)
15) Install the wheel and tighten the wheel nuts to
specified torque.
Tightening torque:
90 N·m (9.2 kgf-m, 66 ft-lb)
C: DISASSEMBLY
1) Using the ST1, support the housing and hub se-
curely.
2) Attach the ST2 to housing and drive the hub out.
ST1
927060000 HUB REMOVER
ST2 927080000 HUB STAND
If the inner bearing race remains in hub, remove it
with a suitable tool (commercially available).
NOTE:
Be careful not to scratch the polished area of hub.
CAUTION:
Do not reuse the bearing if the hub was re-
moved.
DS-00104
ST
DS-00048
DS-00049
ST1
ST1
ST2
ST2
DS-00050