Subaru Impreza 2003, Service Manual

Page: 1123 / 3610

CO(H4DOTC)-15
COOLING
RADIATOR SUB FAN SYSTEM
16 CHECK POOR CONTACT.
Check poor contact in connector between sub
fan and ECM.
Is there poor contact in con-
nector between sub fan motor
and ECM? Repair the poor
contact connector. Record the DTC.
Repair the trouble
cause. <Ref. to
EN(H4DOTC)-39,
Read Diagnostic
Trouble Code
(DTC).>
17 CHECK POWER SUPPLY TO SUB FAN MO-
TOR.
CAUTION:
Be careful not to overheat the engine during
repair.
1)Turn the ignition switch to OFF.
2)Disconnect the connector from sub fan
motor.
3)Start the engine, and warm it up until engine
coolant temperature increases over 96
°
C
(205
°
F).
4)Turn the A/C switch ON.
5)Measure the voltage while A/C compressor
is rotating.
6)Measure the voltage between sub fan motor
connector and chassis ground.
Connector & terminal
(F16) No. 2 (+) — Chassis ground (
−−−−
):
Is the voltage more than 10 V? Go to step 18. Go to step 20.
18 CHECK POOR CONTACT.
Check poor contact in sub fan motor connec-
tor.
Is there poor contact in sub fan
motor connector? Repair the poor
contact in sub fan
motor connector. Go to step 19.
19 CHECK SUB FAN MOTOR.
Connect the battery positive (+) terminal to ter-
minal No. 2, and ground (
−
) terminal to termi-
nal No. 3 or No. 4 of sub fan motor connector.
Does the main fan rotate? Repair the poor
contact in sub fan
motor connector. Replace the sub
fan motor with a
new one.
20 CHECK POWER SUPPLY TO SUB FAN
RELAY2.
1)Turn the ignition switch to OFF.
2)Remove the sub fan relay2 from A/C relay
holder.
3)Measure the voltage between sub fan relay2
terminal and chassis ground.
Connector & terminal
(F27) No. 18 (+) — Chassis ground (
−−−−
):
Is the voltage more than 10 V? Go to step 21. Go to step 22.
21 CHECK POWER SUPPLY TO SUB FAN
RELAY2.
1)Turn the ignition switch to ON.
2)Measure the voltage between sub fan relay2
terminal and chassis ground.
Connector & terminal
(F27) No. 20 (+) — Chassis ground (
−−−−
):
Is the voltage more than 10 V? Go to step 23. Go to step 24.
22 CHECK 30 A FUSE.
1)Remove the 30 A fuse from A/C relay holder.
2)Check the condition of fuse.
Is the fuse blown out? Replace the fuse. Go to step 23.
23 CHECK POWER SUPPLY TO A/C RELAY
HOLDER 30 A FUSE TERMINAL.
Measure the voltage of harness between A/C
relay holder 30 A fuse terminal and chassis
ground.
Connector & terminal
(F27) No. 3 (+) — Chassis ground (
−−−−
):
Is the voltage more than 10 V? Repair the open
circuit in harness
between 30 A fuse
and sub fan relay
terminal.
Repair the open
circuit in harness
between sub fuse
box connector and
30 A fuse terminal.
Step Check Yes No