Subaru Impreza 2003, Service Manual

Page: 1104 / 3610

EX(H4DOTC)-12
EXHAUST
CENTER EXHAUST PIPE
14) Install the universal joint (RHD model).
(1) Align the bolt hole on long yoke side of uni-
versal joint with the cutout at serrated section of
shaft end, and insert the universal joint.
(2) Align the bolt hole on short yoke side of uni-
versal joint with the cutout at serrated section of
gearbox assembly. Lower the universal joint
completely.
(3) Temporarily tighten the bolt on short yoke
side. Raise the universal joint to make sure the
bolt is properly passing through the cutout at
serrated section.
(4) Tighten the bolt on long yoke side, then that
on the short yoke side.
Tightening torque:
24 N·m (2.4 kgf-m, 17.4 ft-lb)
CAUTION:
• Make sure that the universal joint bolts are
tightened through notches in shaft serration.
• Excessively large tightening torque of uni-
versal joint bolts may lead to heavy steering
wheel operation.
Standard clearance between gearbox to DOJ:
More than 15 mm (0.59 in)
15) Install the under cover.
16) Lower the vehicle.
17) Install the intercooler bracket.
18) Install the intercooler. <Ref. to IN(H4DOTC)-
11, INSTALLATION, Intercooler.>
19) Align the center of roll connector. <Ref. to AB-
11, ROLL CONNECTOR, INSPECTION, Inspec-
tion Locations After a Collision.>
EX-00008
EX-00007