Subaru Impreza 2003, Service Manual

Page: 2138 / 3610

FS-22
FRONT SUSPENSION
FRONT STRUT
7) Pull the piston rod fully upward, and install the
rubber seat and spring seat.
NOTE:
Ensure that the upper spring seat is positioned as
shown in the figure.
8) Install the strut mount to the piston rod, and then
tighten a new self-locking nut temporarily.
9) Using a hexagon wrench to prevent strut rod
from turning, tighten the self-locking nut with ST.
ST
927760000 STRUT MOUNT SOCKET
Tightening torque:
55 N·m (5.6 kgf-m, 41 ft-lb)
10) Loosen the coil spring carefully.
E: INSPECTION
Check the disassembled parts for cracks, damage
and wear, and replace with new parts if defective.
1. DAMPER STRUT
1) Check for oil leakage.
2) Move the piston rod up and down to check that it
operates smoothly without any binding.
3) Play of piston rod
• Measure the play as follows:
Fix outer shell and fully extend the rod. Set a dial
gauge at the end of rod: L [10 mm (0.39 in)], then
apply a force of W [20 N (2 kgf, 4 lb)] to threaded
portion. With the force of 20 N (2 kgf, 4 lb) applied,
read dial gauge indication: P
1
. Apply a force of 20 N
(2 kgf, 4 lb) in the opposite direction of “W”, then
read dial gauge indication: P
2
.
Limit of play (P
1
+ P
2
):
0.8 mm (0.031 in)
If the play is greater than limit, replace the strut.
2. STRUT MOUNT
Check the rubber part for creep, cracks and deteri-
oration, and replace it with a new one if defective.
3. DUST COVER
If any cracks or damage are found, replace it with a
new one.
4. COIL SPRING
One having permanent strain should be replaced
with a new one. When the vehicle posture is un-
even, although there are no considerable reasons
like tire puncture, uneven loading, etc., check the
coil spring for its free length referring to specifica-
tions, cracks, etc., and replace it with a new one if
defective.
5. HELPER
Replace it with a new one if cracked or damaged.
(1) Outside of body
FS-00044
(1)
FS-00041
ST
FS-00046
W
L