Subaru Impreza 2003, Service Manual

Page: 253 / 3610

ME(H4SO)-41
MECHANICAL
ENGINE ASSEMBLY
(5) Install the front side V-belt, and adjust it.
<Ref. to ME(H4SO)-44, FRONT SIDE BELT, IN-
STALLATION, V-belt.>
(6) Install the resonator chamber.
Tightening torque:
33 N·m (3.4 kgf-m, 24.6 ft-lb)
11) Tighten the nuts which hold the lower side of
transmission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
12) Tighten the nuts which install the front cushion
rubber onto crossmember.
Tightening torque:
85 N·m (8.7 kgf-m, 63 ft-lb)
NOTE:
Make sure the front cushion rubber mounting bolts
(A) and locator (B) are securely installed.
13) Install the front and center exhaust pipe. <Ref.
to EX(H4SO)-7, INSTALLATION, Front Exhaust
Pipe.>
14) Connect the following hoses.
(1) Fuel delivery hose, return hose and evapo-
ration hose
(2) Heater inlet and outlet hoses
(3) Brake booster vacuum hose
15) Connect the following connectors.
(1) Engine ground cables
Tightening torque:
14 N·m (1.4 kgf-m, 10.1 ft-lb)
(2) Engine harness connectors
(3) Generator connector and terminal
(4) A/C compressor connectors
16) Connect the following cables.
(1) Accelerator cable
(2) Cruise control cable (Model with cruise con-
trol)
17) Adjust each connected cable.
18) Install the air cleaner case stay.
Tightening torque:
16 N·m (1.6 kgf-m, 11.6 ft-lb)
19) Install the A/C pressure hoses.
<Ref. to AC-36, INSTALLATION, Hose and Tube.>
20) Install the radiator to vehicle. <Ref. to
CO(H4SO)-22, INSTALLATION, Radiator.>
21) Install the air intake duct and air cleaner case.
<Ref. to IN(H4SO)-6, INSTALLATION, Air Intake
Duct.> and <Ref. to IN(H4SO)-5, INSTALLATION,
Air Cleaner Case.>
22) Install the under cover.
23) Install battery in the vehicle, and then connect
the cables.
24) Fill engine coolant.
<Ref. to CO(H4SO)-14, FILLING OF ENGINE
COOLANT, REPLACEMENT, Engine Coolant.>
25) Check the ATF level and correct if necessary.
(AT model)
<Ref. to 4AT-31, INSPECTION, Automatic Trans-
mission Fluid.>
26) Charge the A/C system with refrigerant.
<Ref. to AC-21, OPERATION, Refrigerant Charg-
ing Procedure.>
27) Remove the front hood stay, and then close the
front hood.
28) Take off the vehicle from lift arms.
C: INSPECTION
1) Make sure the pipes and hoses are installed cor-
rectly.
2) Make sure the engine coolant and ATF are at
specified levels.
IN-00044
ME-00219
ME-00056
(A)
(A)
(B)
(B)