25
S
10. Reconnect the cables to the terminal block.
Cantilever
Wall bracket
green/yellow
connect to
green/yellow
white
connect to
red
black
connect to
black
11. Reinstall the cover cap (1).
12. Reinstall cap screws (2).
13. Install brake screw (3).
14. Install Spring Arm as instructed in section 7.6.
15. Install Light Head as instructed in section 7.9.
7.5. Replacing a Spring Arm for Light Head or Flat Panel Support Arm (Ceiling
Suspension)
WARNING:
Before performing the following steps, the electricity for the Lights and/or
Monitors has to be powered OFF.
CAUTION:
There is a risk of injury from spring-loaded joints. If the spring arm is
released under tension, it will move quickly and uncontrollably, possibly causing
injury or damage to equipment.
1. Hold onto the spring arm when installing or removing the light head.
2. Avoid putting pressure on the spring arm and releasing it suddenly.
3. Spring arm should always have the stop set for the spring arm to be parallel.
1. Remove the Light Head or Monitor Yoke as
instructed in section 7.9.
2. Remove the round-headed screw (7) from the
thread of the safety screw and cover (6).
3. Remove the brake screw (5), round screw (4),
and safety screw (3).
Summary of Contents for Berchtold CHROMOPHARE
Page 1: ...CHROMOPHARE Surgical Lights Single and Combination Lights Service and Parts Manual ...
Page 2: ......
Page 64: ... 59 S ...
Page 65: ...60 S ...
