71
S
12. Reinstall tube using the four screws removed in earlier step.
13. Install Led face glass using gasket tool.
14. Install plastic ring for focus mechanism.
15. Install light head on to spring arm.
16. Adjust brakes in order to achieve the desired braking action.
17. Complete operational check of light, cardanic and spring arm.
8.1.3
Cardanic Replacement for FXX8 Light Heads (F-Gen)
CAUTION There is a risk of injury from spring-loaded joints. If the spring arm is
released under tension, it will move quickly and uncontrollably, possibly causing
injury or damage to equipment.
1. Hold onto the spring arm when installing or removing the light head.
2. Avoid putting pressure on the spring arm and releasing it suddenly.
3. Spring arm should always have the stop set for the spring arm to be parallel
with the floor when servicing.
Note: F Generation lights have a newly designed cardanic. To change or replace the
cardanic will require the removal and reinstallation of an internal blind single snap
ring. This requires a special tool shown below. This tool is only for use by factory trained
service technicians.
8.1.4
F-Generation Cardanic Security Tool:
F-Gen Complete Tool:
F-Gen Tool with 1-1 on the left and 1-2 on the right
:
1. Remove Light from Spring Arm and place on a working Surface.
Summary of Contents for Berchtold CHROMOPHARE
Page 1: ...CHROMOPHARE Surgical Lights Single and Combination Lights Service and Parts Manual ...
Page 2: ......
Page 64: ... 59 S ...
Page 65: ...60 S ...
