Still RX70-40, Original Instructions Manual

Page: 284 / 392

4
Operation
Display messages
– Top up the AdBlue
®
.
ASH LOAD message
If the message
ASH LOAD
appears on the
display, the particle filter has become clogged
with ash. Repair must be performed by the
authorised service centre.
– Notify the authorised service centre.
GLOW message
If the
GLOW
message appears in the display,
the engine is being preheated.
Preheating can take up to 22 seconds. If the
engine is already at operating temperature,
preheating is not performed.
– Once the message goes out, start the
engine.
HYBRID SYSTEM message
If the message
HYBRID SYSTEM
is shown
on the display, the energy storage system has
been deactivated because of an error.
The truck remains operational. However, the
fuel consumption increases marginally.
– Contact the authorised service centre in
order to rectify the error.
HYDRAULIC PUMP message
If the
HYDRAULIC PUMP
message appears
on the display, there was an error in the
hydraulic-pump volume control.
The engine can be overloaded and stall as
a result of the overload. This causes the
assisted steering and regenerative braking
to malfunction. Further operation of the truck
is therefore not permissible. The driving speed
is limited to 5 km/h.
– Contact the authorised service centre in
order to rectify the error.
272 57348011850 EN - 02/2019 - 11