Still FM-X 10 N, Original Instructions Manual

Page: 306 / 380

Hook on the lifting straps (drive side, on the
left)
–
If necessary, remove the bottom plate of the
driver's compartment to make it easier to
loop the strap around the strut on the floor
of the truck chassis.
–
If necessary, rotate the drive wheel into the
45° position to make it easier to loop the
strap around the strut on the floor of the
truck chassis. Before attaching the straps,
make sure that the battery male connector
is disconnected. Make sure that the emer-
gency off switch is actuated.
–
Guide the loop of the lifting strap (1) from
below through the round opening (2) in the
wheel arch.
–
Guide the loop of the lifting strap down-
wards again under the reach cylinder and
through the rectangular opening (3). Ensure
that the belts do not put pressure on the
reach cylinder (4).
NOTE
The space under the reach cylinder for the lift-
ing strap can be increased by extending the
reach cylinder.
–
Guide the loose ends of the lifting strap
through the loop.
–
Guide the loose ends of the lifting strap to
the right and left of the side chassis support
(5) and upwards towards the bridge piece.
–
Hook the lifting straps onto the bridge piece
and secure the straps in place.
45°
2
1
3
4
2
3
5

Operating
4
Transporting the truck
294 50988078001 EN - 11/2021 - 10