Still FM-X 10 N, Original Instructions Manual

Page: 117 / 380

The drive function is only enabled if:
●
The parking brake has been released
●
The seat switch has been actuated but the
accelerator pedals have not
●
One of the accelerator pedals is then actu-
ated
●
The switches are all functioning correctly
NOTE
The parking brake is released once one of the
accelerator pedals is actuated slightly.
Enabling the truck functions using the
seat switch
The seat switch monitors whether or not a
driver is seated on the driver's seat. The seat
switch must always be actuated first, and then
the foot switch. Only then can the driver select
the drive function or the hydraulic functions.
If the switch malfunctions during operation, the
truck is braked to a standstill or to a speed of
2.5 km/h, according to truck type, and a corre-
sponding message appears in the display and
operating unit.
If the seat switch is defective or if the switch
was not actuated at least once within an eight-
hour period, the controller also assumes that
there is a malfunction.
–
If the problem persists after the driver's seat
has been occupied once and then vacated,
please contact the authorised service cen-
tre.
NOTE
If the truck remains switched on for longer
than eight hours in total, the switch status of
the seat switch must change at least once. As
a rule, this does happen during normal opera-
tion. If this has not happened, the seat switch
must be released and then re-actuated once
while the truck is switched on.
Operating
4
Driving
105 50988078001 EN - 11/2021 - 10