STEYR MOTORS Marine Engine 2012 Series, Service Manual

Page: 237 / 274

Electrical System
Z001138-1_2013-02-01 10/47
06.02 Starter motor
06.02.01 Replace starter motor
1. Disconnect battery.
2. Loosen te30 (battery main cable)
on magnetic switch by means of SW13.
3. Remove start signal wiring (terminal 50)
from blade terminal resp. M4 screw
(depending on model).
4. Loosen M10 Allen screws SW8 of starter
motor.
5. Remove starter.
Assembly is done in reverse order.
NOTE:
Tighten Allen screws M10 with a torque of 45
Nm +/- 2 .
Tighten M10 nut at starter motor solenoid for
battery positive cable (30) with a torque of
15
Nm +/- 3 .
Tighten M4 screw for stud signal (50) with a
torque of
2 Nm +/- 0,3 .
50