INSTRUCTION FOR 'R' TYPE MOTORS: 35R AND 45R
Non-compliance with the specification might cause risk for life or health and can determine proper work of the roller shutter.
We strongly recommend to comply with the specification.
Installation of the tubular motor should be performed by specialists with 1kV or higher SEP-certified electrician's licence
(SEP - Association of Polish Electrical Engineers) or equal license.
www.sukcesgroup.pl
R type motors with built-in radio receiver are wireless and can
be controlled with a remote. Motor is designed to automate
roller shutters or roller gates. Motors are equipped with
microswich, that makes transmitter programming much
easier. Mechanically set limit positions allow roller shutter to
stop on desired level. Motors are compatible with all YOODA
brand remotes.
Radio receiver memory:
up to 20 transmitters.
Max time of continous work:
4 min.
Power supply:
230 V / 50 Hz
Operating temperature:
od -25°C from to 50°C
Stopień ochrony:
IP 44
Maximal time of continuous work is 4 minutes. After that time thermal protection will be activated preventing motor form overheating.
After that motor will be disabled for about 20 minutes until it cools down.
Safety measures
Before installing or using motor please read the following instruction. Installation of the tubular motor should be performed by special-
ists with 1kV or higher SEP-certified electrician's licence (SEP - Association of Polish Electrical Engineers) or equal license. Montage
should be done by a qualified installer with compliance with all requirements and norms implemented in the country of installation as
well as should transfer all information concerning usage and maintenance of the device to the user. Non-compliance to this instruction
of installation and usage can present risks to health and safety of installer and/or user and may cause failures in correct operation of
the roller shutter. Negligence of mentioned safety measures may lead to the lapse of liability for damages in the event of damage or
loss.
Motors torque parameter should be adequate to the
weight of the roller shutter curtain.
Wiring should be mounted in a way preventing
water from entering the tubular motor.
Electrical system control should be performed
regularly to detect any signs of use or damage
of the motor.
Electrical supply needs to be disconnected before
conducting any maintenance, cleaning and/or repair
work.
power supply cable
radio receiver
limit switches
limit position
regulators
motor
brake
gear
antenna
microswitch
capacitor
General information