Receiver can be controlled by up to 20 transmitters.
Longer than 5 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
Programming another transmitter
Deleting memory of motors radio receiver will cause for all programmed transmitters to be lost.
Longer than 5 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
Longer than 5 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
To reverse this procedure please repeat the instruction.
Deleting radio receiver memory
Activating impulse mode
INSTRUCTION FOR 'R' TYPE MOTORS: 35R AND 45R
Non-compliance with the specification might cause risk for life or health and can determine proper work of the roller shutter.
We strongly recommend to comply with the specification.
Installation of the tubular motor should be performed by specialists with 1kV or higher SEP-certified electrician's licence
(SEP - Association of Polish Electrical Engineers) or equal license.
www.sukcesgroup.pl
Motor will
make a sound.
Roller shutter
will make an
up/down move.
Motor will
make a sound.
Roller shutter will
make an up/down
move as the motor will
make few sounds.
Press
programming button (P2)
on already programmed
and working remote (A).
Press
programming button (P2)
on already programmed
and working remote (A).
Press
programming button (P2)
on new remote (B).
Both remotes
controll motor.
Motor will
make a sound.
Roller shutter
will make an
up/down move.
Motor will
make a sound.
Roller shutter will
make an up/down
move as the motor will
make few sounds.
All previously programmed
and working remotes have
been deleted.
Press
programming button (P2)
on already programmed
and working remote.
Press
STOP button
on previously
used remote.
Press
programming button (P2)
on used remote.
Motor will
make a sound.
Roller shutter
will make an
up/down move.
Press
programming button (P2)
on already programmed
and working remote.
Press
programming button (P2)
on previously used remote.
Roller shutter will
make an up/down
move as the motor will
make few sounds.
When motor is in impulse
mode single push of a button
on the remote will cause
motor to make
1/16 of a full turn.
Press
UP button
on previously
used remote.
Motor will
make a sound.