Finishing Cont.
☐ ☐
Insert pushrod into housing until the bent
end is in line with the control horn.
☐ ☐
Trim pushrod 1/4 in. beyond where it will
pass through the EZ Connector.
☐ ☐
Re-install pushrod, passing it through the
EZ Connector, and secure to control horn
with a Micro EZ Link [DUB849]. Safety
the EZ Link by sliding a 1/8 in. length of
silicone tubing over the Link and pushrod.
☐
Repeat steps marked
☐
☐
for elevator on the
left side.
☐
Flying Strut Mounts:
Trim the arms off of
four Micro II Control Horns [DUB919] at about
a 45 degree angle, leaving triangular shaped
tabs. Slightly sand point of triangle round.
☐
Using .032 or slightly larger drill, make a hole
near the tip of each triangle.
☐
Trim about half of the length from the posts
on the strut mount.
Build Instructions
SkyScout 480
- Build Instructions © 2010 Stevens AeroModel, all rights reserved.
!
Page 44
