Finishing Cont.
☐ ☐
Trim one arm from the large control horn
that came with your HS-50 servo.
☐ ☐
Install a Mini EZ Connector [DUB845] to
the
middle
hole on the control horn.
☐ ☐
Electronically center servo. Mount horn
on servo at a 45 degree angle, pointing
towards leading edge and center of wing.
☐ ☐
Cut a length of .032 in. wire to 3-3/4 in.
Make a 90 degree bend 1/8 in. from end.
☐ ☐
Pass pushrod through the EZ Connector,
and secure the bent end to the control
horn with a Micro EZ-Link [DUB849].
Safety link with short length of fuel tubing
in same manner as elevator and rudder.
☐
Repeat previous
☐
☐
steps to finish aileron
on opposite side of wing.
☐
Flying Struts:
Trim the arms off of four Micro
II Control Horns [DUB919] at about a 45
degree angle, leaving triangular shaped tabs.
Sand tip of triangle round.
Build Instructions
SkyScout 480
- Build Instructions © 2010 Stevens AeroModel, all rights reserved.
!
Page 53
Wing Center
Wing Leading Edge
