Procedure
To connect the Ethernet cables to PoE device, follow the steps below:
Step
Action
1
Use the tool (item 1) to remove the cover of PoE device.
2
Pass the S-FTP cables through the tie-wraps.
3
Use the tool (item 1) to remove the clamp and then plug the SFTPcables into the
GbE IN
and
OUT
receptacles of PoE
4
Use the tool (item 1) to screw the clamp for securing the cables in place, as shown
below:
No.
Connection Details
1
S-FTP
cable used to interconnect PoE Gbe IN receptacle with the
network equipment for passing traffic.
2
S-FTPcable used to interconnect PoE Gbe OUT receptacle with SM
CIRIUS AO receptacle for passing traffic, inband management &
power.
3
Grounding cable used to interconnect PoE terminal ring with the
grounding bar.
5
Use the tool (item 1) to reinstall the cover of PoE device.
D
O NOT connect cable No.2 to any network equipment.
There is risk of switches /
routers failure due to potential power. Use the cable for connection to SM CIRIUS AO
Summary of Contents for SM Cirius AO
