Spirit 16207879500, Owner'S Manual

Page: 35 / 54

Customer service 1-888-707-1880 Dyaco Canada Inc 2018
Email: customerservice@dyaco.ca
35
UPDATE SOFTWARE
NOTE:
Updating Software requires a Blank USB memory stick and a computer to transfer updates from service website, to
USB, to console. NO other material besides the updates should be in USB drive.
- Purpose of this setting is to Update Console Software with the use of a USB inserted
into console.
 USB port is located underneath the console.
 Press PLAY KEY to display BOOTLOADER – OFF.
o
Press + KEY or – KEY switch to BOOTLOADER – ON.
o
Allow console to Power Down.
o
Wait until console has Turned OFF.
 Powering down could take up to 10 minutes if bike had been
ridden for a time before updating software.
o
Insert the USB drive, wait 1 to 2 minutes.
o
Pedal bike to awaken console.

If successful, displays UPDATE DONE.

If unsuccessful, displays UPDATE FAIL, check USB for proper
insertion and attempt again.
 Press PLAY KEY to exit to setting screen.

Press + KEY for next screen or RESET CONSOLE to exit MAINTENANCE
MODE.
LED BRIGHTNESS
- Purpose of this setting is to change the brightness of the display.

Press PLAY KEY to change setting.
 Default brightness setting is 2.

Press + KEY or – KEY switch between LED Brightness 1, 2, or 3.
 Press PLAY KEY to accept and exit to setting screen.
 Press + KEY for next screen or RESET CONSOLE to exit MAINTENANCE MODE.
ANT+ ID SETUP
- Purpose of this setting is allowing numbering of the bike when using a Leaderboard™ software, such as Performance
IQ or similar.
 Press PLAY KEY to change setting.

Console will display ANT+ ID SETUP, and 0 on the lower console and flash.

Press + KEY or – KEY adjust the bike number to the desired number. Over 1,000 are available.

Press PLAY KEY to accept, bike number will stop flashing momentarily then turn off indicating set.
 Press + KEY for next screen or RESET CONSOLE to exit MAINTENANCE MODE.