Customer service 1-888-707-1880
Dyaco Canada Inc 2018
Email: [email protected]
30
L
ap
P
rogram
LAP PROGRAM allows riders to perform repeated measures of Time and Distance efforts. The program will compare your
current LAP with your previous LAP. Rider may perform as many LAPS as desired, but only the last 5 LAPS will display in the
WORKOUT RESULTS.
RESET CONSOLE then press and hold the PLAY KEY for 3 seconds.
-
LAP ENABLED displays on screen.
If DISABLED is displayed, Press PLAY KEY to ENABLE.
o
ENABLED setting is required for LAP Program to run and for LAP RESULTS to display in WORKOUT
SUMMARY.
Press and hold PLAY KEY for 3 seconds.
WARM UP Mode flashes 3 times.
Press PLAY KEY when ready to go.
NOTE:
Console continues in WARM UP Mode until PLAY Key is pressed.
-
Upon pressing PLAY KEY, LAP Program will begin.
Pressing PLAY KEY displays ENYOY THE RIDE followed by home screen.
ANY data collected during WARM UP Mode will be erased.
Home screen will appear and display: Level, RPM, Time, Distance, Watts, Heart Rate.
Press + or – KEY on either Forward Control Pad or handlebar ends to adjust resistance.
PREPARATION PHASE
-
At this point rider is in a Preparation Phase of the ride; LAP data has not yet started to record.
TO START LAP
-
At desired time of Preparation Phase, press PLAY KEY.
THIS.LAP displays on lower section of console, replacing display of Watts and Heart Rate.
o
The Time display will reset to 0.00.
o
The Distance display will reset to 0.00.
LAP is being recorded.
TO END LAP
-
Press PLAY KEY again and display temporarily goes away with END LAP displayed on lower section of console.
Display returns with Time paused and THIS.LAP displayed on lower section of console.
After 5 seconds, full display returns with total accumulated Time and Distance from beginning of program. Watts
and Heart Rate return to lower section of screen.
-
LAP has been recorded.
-
At this point rider is in a Recovery Phase prior to beginning another LAP or ending ride.
