Customer service 1-888-707-1880
Dyaco Canada Inc 2018
Email: [email protected]
25
P
air
H
eart
R
ate
D
evice
NOTE: HR ZONE program requires connection of a Heart Rate Strap prior to using the program.
NOTE:
Connecting console to a Heart Rate Strap can be accomplished prior to entering PROGRAMS Mode during an initial
warm-up or after entering PROGRAMS Mode.
-
If user puts on a HR strap after initially beginning PROGRAM Mode and needs to pair
device with console.
Reset console by press simultaneously and hold + KEY and PLAY KEY for 3
seconds.
CONSOLE RESET displays on console.
Press and hold PLAY KEY for 3 seconds.
LAP DISABLED display on screen.
o
Press + KEY once.
o
PAIR HR DEVICE displays on console.
Press PLAY KEY to SCAN HR DEVICES.
-
If sensors are detected number of sensors displays.
FOR EXAMPLE:
2 SENSORS FOUND Press if device shown is not your own.
MYZONE-12345678 (SN# or your MYZONE device displays).
ANT+ 12345 (id # for your ANT+ device displays).
NOTE:
User will need to be familiar SN # of their MYZONE module, located on backside.
-
Select one sensor.
-
Press PLAY KEY.
-
WARM UP Mode flashes 3 times.
-
PRESS PLAY KEY, WHEN READY TO GO displays on console.
-
IF ZER0 SENSORS FOUND
RE-SCAN DISPLAYS
Dampen HR contacts on strap if dry
Press PLAY KEY to RE-SCAN
-
If user was in PROGRAM Mode when pairing heart rate sensor, then user will need to return to PROGRAM Mode to
use LAP, HR ZONES or POWER ZONES programs.
-
To Return to PROGRAMS Mode
RESET console by pressing PLAY KEY and + KEY simultaneously for 3 seconds.
Press and hold PLAY KEY for 3 seconds.
-
DO NOT CONNECT
If not wanting to connect a heart rate strap, press + KEY until screen displays DO NOT CONNECT.
Press PLAY KEY and screen displays WARM UP, blinking 3 times, then reverting to WARM UP Mode. The HR
on lower display will remain blank.
